Bambu Cool Plate SuperTack is not compatible with Support for PLA/PETG when printing directly on the first layer. Printing Support for PLA/PETG directly on the surface of the build plate will damage the build plate. Therefore, when Bambu Studio detects that there is Support for PLA/PETG in the first layer after slicing, an error message will be displayed and printing will be prohibited.
¶ Printing suggestions
- It is recommended to select to use support filaments only in the support interface as follows when using Support for PLA/PETG.
- When the printed model cannot avoid using support filament in the first layer, you can avoid printing Support for PLA/PETG directly on the build plate by adding raft layers (the number of raft layers is not less than 2).
