¶ Video
¶ Test Conditions
-
Laser Power: 10W
-
Material: 3mm Basswood Plywood
-
Laser tasks were carried out continuously for 3 hours (cutting a total of 7 plates)
-
The resulting fumes are exhausted outside the printer through the Air Purifier
¶ Recording
¶ Preparation before laser task
Before starting the laser task, visually inspect the interior of the printer to ensure that the XY-axis motion assemblies are clean, and there is no dust on the lens of the nozzle, tool head camera.
 |
 |
¶ Start laser task
After 3 hours of laser cutting and engraving, the laser artwork shown in the image below was obtained.
 |
 |
 |
¶ Cleaning tips
After completing the 3-hour laser task, there were no visible dust particles observed on the XY-axis, nozzle camera, or tool head camera.
 |
 |
Simply wipe with non-woven fabric to clean.
Wipe the XY-axis.
 |
 |
 |
Wipe the live view camera, nozzle camera and toolhead camera.
 |
 |
Wipe the chamber exhaust fan.
 |
 |
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!