The active chamber exhaust is installed on the right inner lining of the printer, and the chamber exhaust fan is mounted on the inner side of the exhaust. When the active chamber exhaust is open, it allows the air inside the printer chamber to be vented out, while closing it provides a sealed environment for the printer. A total of 7 active chamber exhausts are installed on the printer.
The spare parts for the active chamber exhaust include the following:
The replacement of the H2D active chamber exhaust does not involve the removal or installation of screws.
IMPORTANT!
It's crucial to power off the printer before conducting any maintenance work, including work on the printer's electronics and tool head wires. Performing tasks with the printer on can result in a short circuit, leading to electronic damage and safety hazards.
During maintenance or troubleshooting, you may need to disassemble parts, including the hotend. This exposes wires and electrical components that could short circuit if they contact each other, other metal, or electronic components while the printer is still on. This can result in damage to the printer's electronics and additional issues.
Therefore, it's crucial to turn off the printer and disconnect it from the power source before conducting any maintenance. This prevents short circuits or damage to the printer's electronics, ensuring safe and effective maintenance. For any concerns or questions about following this guide, we recommend submitting a technical ticket regarding your issue and we will do our best to respond promptly and provide the assistance you need.
Before starting the replacement, you can ensure the active chamber exhaust is in the state shown in the image below. You can manually adjust the position by pushing the exhaust upward, then turn off the printer.
The replacement of the active chamber exhaust does not require removing the rear panel.
Hold the middle of the active chamber exhaust and slightly bend it. Pull the right side out of the inner lining, then remove the outer latch on the left side. Finally, pull out the latch connected to the metal sheet to remove the active chamber exhaust.
If only one exhaust is damaged, simply remove the damaged one.
Insert the latch on the left side of the new exhaust into the metal sheet, then insert the outer latch on the left side into the inner lining. Finally, hold the middle of the exhaust to bend it, and insert the latch on the right side.
The exhaust is properly installed and secure. After connecting the power and turning on the printer, the exhaust should automatically open and close.
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!