The fine point blade is the core engraving component installed on the cutting module.

H2DL
The fine point blade is broken.
- Use the Tool Assist to remove the blade holder. If you don't have a printing tool, you need to hold the round edge of the blade holder and pull it downwards to remove it.
Note: The blade is very sharp, please operate with care to avoid injury!

- Hold the end of the blade tip and use the Tool Assist to remove the sharp blade. Please operate with caution!

- If you don't have a printing tool, you can also use the red silicone cover of the new sharp blade to help remove the blade to avoid accidentally cutting your hand.


- Take the sharp blade out of the red silicone sleeve, use the tool to carefully hold the sharp blade, and insert it into the blade holder. The blade holder has a magnetic function, and the blade will automatically be magnetically attracted into place after being pushed into a certain depth.
Note: The blade is very sharp, please operate with care to avoid injury!

- Use the auxiliary tool to carefully insert the blade holder back into the cutting module.

We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!