Front Door Mounting Kit are related accessories used with the front glass door of the O1 series printer, including:
Generally, the front door accessories need to be replaced only when the hinges are deformed. When used on H2D printers, you usually only need to replace the upper and lower hinges, and the magnets and rubber strips do not need to be replaced.
Front Door Mounting Kit
H1.5/2.0 Allen key
Glass is fragile, so be careful to hold it steady when removing and installing it to prevent it from falling. If there is any damage to the glass, be careful not to hurt your hands.
Use an H2.0 Allen key to remove the four screws that secure the front door, two on the top and two on the bottom. Be careful to hold the front glass door with your hands to prevent it from falling.
![]() |
![]() |
![]() |
Unscrew the 2 screws on the upper hinge, remove the door hinge, and do the same with the lower hinge.
![]() |
![]() |
If your silicone strips are not damaged, you do not need to replace it.
You can directly tear off the left and right silicone strips.
![]() |
![]() |
If your silicone strips are not damaged, you do not need to replace it.
The left and right silicone strips are different. You can refer to the picture below to distinguish the left and right silicone strips, and then stick the silicone strips to the corresponding positions.
![]() |
![]() |
Align the holes, put in the upper door hinge, tighten the 2 screws, and do the same with the lower hinge
![]() |
![]() |
Align the 4 screw holes on the front door glass with the screw positions on the opener and install them, and hold them steady with your hands. Then screw in 4 front glass door screws one by one.
![]() |
![]() |
![]() |
Visually inspect the appearance to confirm that the screws are not floating; manually open and close the front glass door, and the movement is smooth and the closed position is normal.
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!