¶ Error Description
Whenever the printer is powered on again, the motors are restarted, or a motor loses steps, the laser module must be recalibrated before it can be used. Otherwise, laser tasks cannot be initiated.
¶ Troubleshooting
¶ Solution
Perform laser module mounting calibration from the HMS page or the Toolbox page.
You can also access the laser module offset calibration from the “Settings” → “Toolbox” menu.
- Install the Laser Module
- Place the Laser Platform and Laser Test Material
- Close the door and the top cover.
- Press and hold the button for 1 second to start calibration.
¶ Equivalent Codes
The following HMS codes all indicate the same type of error.
| HMS Code | Error Description |
|---|---|
| 0500-0400-0002-0035 | The Laser Module needs calibration to get the focus position. Please perform mounting calibration before use. (about 30 second) |
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!