¶ Error Description
Every time the printer is powered on again, a mounting calibration for the cutting module is required; otherwise, die-cutting tasks cannot be initiated.
¶ Resolution Steps
Perform the Cutting Module Mounting Calibration from the HMS Page or the Toolbox Page
- You can also find the entry for the cutting module mounting calibration by clicking on "Settings" and then "Toolbox".
- Install the Cutting Module
- Place the Cutting Mat
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!