¶ Issue Description
The cutting module is not correctly installed, preventing the calibration of the cutting module and the initiation of cutting printing tasks.
¶ Troubleshooting
¶ Tools, Equipment and Materials
None
¶ Solutions
-
Align the cutting module with the toolhead's sliding groove and slide the cutting module downward until it is fully seated.
-
Ensure the "Click" mark on the cutting module aligns with the scale line on the toolhead, then tighten the quick-release lever downward.
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!