¶ Issue Description
The failure of the micro ridar calibration may be caused by the following reasons: the calibration sticker being obstructed, dirty, or damaged, which prevents the toolhead camera from accurately identifying the feature points on the sticker, leading to calibration failure. It is recommended to check and ensure the cleanliness and integrity of the calibration sticker.
 |
 |
¶ Troubleshooting
¶ Tools, Equipment and Materials
-
Tissue paper
-
Replacement calibration sticker
¶ Solutions
Check the condition of the calibration sticker
¶ Step 1. Check if the calibration sticker is obstructed or dirty
-
If obstructed, remove the obstruction from the sticker.
-
If dirty, clean the sticker with tissue paper.
¶ Step 2. Check if the calibration sticker is damaged, severely scratched, or cannot be cleaned properly
Remove the old calibration sticker and accurately paste the new calibration sticker in the designated position.
¶ Step 3. Recalibrate
After completing the above steps, initiate the calibration again and observe if it can be completed successfully.
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!