An error occurred during the Live View Camera calibration process, and the Live View Camera calibration cannot be completed.
¶ Fault Location and Resolution Process
- Check if the Live View Camera image is normal, and ensure that the camera privacy cover does not block the lens.
- Check if the Live View Camera is dirty; if there is dirt, wipe the lens.
- Check if the cutting platform on the heatbed has been removed and if the magnetic sheet markers are exposed.
- Check the Live View Camera image to see if there is obvious reflection. If there is reflection, block the right side or front door to prevent ambient light from interfering with the calibration process.
- Repeat the calibration several times. If the problem persists, it is recommended to update the firmware to the latest version and try again. If calibration still fails after multiple attempts, please contact customer support for assistance.
The following HMS codes all represent the same type of fault.
| HMS Code |
Fault Description |
| 0C00-0100-0001-0011 |
Live View Camera calibration failed. Please recalibrate. Before calibration, ensure the following: the cutting platform is cleared, the camera image is clear and upright. |
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!