¶ Issue Description
The positioning marker on the build plate is not detected. Bambu Lab build plates are printed with QR codes to ensure correct placement and alignment.
Possible causes of this warning:
-
The build plate was not aligned when placed (common issue: the build plate is slightly offset from the heatbed toward the door side).
-
The markers are damaged or obscured.
-
A third-party build plate is used.
¶ Troubleshooting
¶ Tools, Equipment and Materials
None
¶ Solutions
Users may adjust the order of these solutions as needed.
¶ Step 1. If you are using a Bambu Lab build plate:
-
Check if the build plate is aligned with the edge of the heatbed and oriented correctly.
-
Inspect the markers to ensure they are intact and clean.
¶ Step 2. If you are using a third-party build plate, simply ignore this message.
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!