¶ Issue Description
-
Function: Detects that the AMS HT front cover is open, which may affect the drying effect or cause the consumables to get damp.
-
Detection principle: When the voltage of the Hall sensor is within a certain range, the front cover is considered to be open.
-
Impact: Affects the drying effect or causes the filament to get damp.
¶ Troubleshooting
¶ Solutions
-
Close the front cover of the AMS HT tightly (press the front cover buckle and hear a crisp sound, which means the front cover is completely closed).
-
If this reminder still appears after closing the top cover, it may be that the magnet at the top cover snap position is damaged or detached. You can check whether the magnet at the position shown in the figure below is still intact and fixed in the original position.
If your AMS 2 Pro is still under warranty, please contact our after-sales support team for more help after trying the above troubleshooting steps.
¶ Equivalent Codes
The following HMS codes represent the same type of issue.
| HMS Code | Description |
|---|---|
| 1800-2400-0002-0009 | AMS-HT A front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
| 1801-2400-0002-0009 | AMS-HT A front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
| 1802-2400-0002-0009 | AMS-HT B front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
| 1803-2400-0002-0009 | AMS-HT B front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
| 1804-2400-0002-0009 | AMS-HT C front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
| 1805-2400-0002-0009 | AMS-HT C front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
| 1806-2400-0002-0009 | AMS-HT D front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
| 1807-2400-0002-0009 | AMS-HT D front cover is open. This may affect the drying performance or cause the filament to absorb moisture. |
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!