The main reason for plywood bending is that humidity changes cause the wood to expand due to moisture absorption or shrink due to drying. When the two sides of the plywood absorb or release moisture unevenly, internal stress imbalance will occur, resulting in bending. Uneven humidity is usually caused by the following reasons:
One side is exposed to high humidity or close to a moisture source, while the other side is in a drier environment;
Under storage conditions, the two sides are in contact with different environments (such as one side is close to the ground).
Due to the characteristics of wood texture, coating treatment, etc., even if the humidity is the same, there may be differences in the rate of moisture absorption, which increases the possibility of bending.
Please store it in a closed environment with stable humidity to reduce the chance of direct contact with changes in air humidity, thus effectively avoiding the occurrence of bending. For example, plywood can be properly stored in a sealed ziplock bag to ensure its good condition**.
If the plywood is bent, you can try to fix it by following the steps below:
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!