Note: There are no spare parts for this item
H2.0/H1.5 hex key
Disconnect the power cord cable.
Refer to the related content of Rear panel to remove the rear panel.
Unscrew 2 screws with an H1.5 hex key (We later added a screw on the left side, which can be unscrewed with an H2.0 hex key), and then remove the excess chute.
![]() |
![]() |
Install the excess chute on the printer, pay attention to the limit buckles on both sides of the chute and install them in place, and do not press the cable.
Lock in 2 screws to secure the excess chute. (We later added a screw on the left side, you can lock it with an H2.0 hex key)
![]() |
![]() |
Refer to the related content of Rear panel to install the rear panel.
Check the appearance and confirm that there is no abnormality.