The P1P package comes with a Screen, Spool Holder, Filament, Spare Hotend, Nozzle Wiping Pads, Power Cord, Unclogging Pin Tool, PTFE Tube, Bambu Scraper, Allen Keys, PTFE Tube Anchor, Textured PEI Plate (Pre-installed on the heat bed of the printer).
NO. | Physical photos | Descriptions | Applications | Marks |
1 |
![]() |
Bambu cool plate | Placed on the heat bed to hold the model. | Pre-installed on the heat bed of the printer |
2 |
![]() |
LCD Screen | ||
3 |
![]() |
Spool holder | It is installed on the back of the printer, fixed with 2 screws. | |
4 |
![]() |
Bambu Reusable Spool | Installed with Filament below | |
5 |
![]() |
Bambu PLA Filament | Installed with reusable spool above | |
6 |
![]() |
spare 0.4 mm hotend | P1P spare hotend, replace the original nozzle when it is damaged. | |
7 |
![]() |
Nozzle Wiping Pad | Spare nozzle Pad, replace it when the Wiping Pad is damaged. | |
8 |
![]() |
Power Cord | ||
9 |
![]() |
Unclogged tool for 0.4 mm nozzle | Special unclogged tool for the 0.4 mm hot end | The hot end has been separated from the extruder and is heated. |
10 |
![]() |
PTFE Tube | ||
11 |
![]() |
Bambu scraper | Print 'Scraper grip' from the built-in files, and then install the scraper to it. | |
12 |
![]() |
H1.5/H2.0 hex keys | Disassembly and assembly tools | |
13 |
![]() |
PTFE Tube Anchor | It is installed on the back of the printer, fixed with 2 screws. | |
14 |
![]() |
Thermal grease |
Improve the thermal conductivity of the thermistor、ceramic heater with the nozzle, which may be used when replacing the above accessories. |
|
15 |
![]() |
Lubricant grease | Special grease for lead screw | |
16 |
![]() |
Spare screws for the extruder | ||
17 |
![]() |
Spare screws for DIY shells | ||
18 |
![]() |
Quick Start Guide |