The P1S package comes with a Screen, Spool Holder, Filament, Spare Hotend, Nozzle Wiping Pads, Power Cord, Unclogging Pin Tool, PTFE Tube, Bambu Scraper, Allen Keys, hotend clip, double-sided tape, and Textured PEI Plate (Pre-installed on the heat bed of the printer).
| NO. | Physical photos | Descriptions | Applications | Marks |
| 1 |
 |
Bambu textured PEI plate | Placed on the heat bed to hold the model. | Pre-installed on the heat bed of the printer |
| 2 |
 |
LCD Screen | ||
| 3 |
 |
Spool holder | It is installed on the back of the printer, fixed with 2 screws. | |
| 4 |
 |
Bambu Reusable Spool | Installed with Filament below | |
| 5 |
 |
Filament (the color is shipped randomly) | Installed with Reusable Spool above | |
| 6 |
 |
spare 0.4 mm hotend | P1S spare hotend, replace the original nozzle when it is damaged. | |
| 7 |
 |
Nozzle Wiping Pad | Spare nozzle Pad, replace it when the Wiping Pad is damaged. | |
| 8 |
 |
Power Cord | ||
| 9 |
 |
Unclogged tool for 0.4 mm nozzle | Special unclogged tool for the 0.4 mm hot end | The hot end has been separated from the extruder and is heated. |
| 10 |
 |
PTFE Tube | ||
| 11 |
 |
Bambu scraper | Print 'Scraper grip' from the built-in files， and then install the scraper to it. | |
| 12 |
 |
H1.5/H2.0 hex keys | Disassembly and assembly tools | |
| 13 |
 |
Thermal grease |
Improve the thermal conductivity of the thermistor、ceramic heater with the nozzle, which may be used when replacing the above accessories. |
|
| 14 |
 |
Lubricant grease | Special grease for lead screw | |
| 15 |
 |
Spare screws for the extruder | ||
| 16 |
 |
hotend retaining clip | The retaining clip is used to hold in place both the ceramic heater and thermistor) | |
| 17 |
 |
double-sided tape | For printed Phone Holder | |
| 18 |
 |
Quick start guide | ||
| 19 |
 |
Disclaimer and Safety Guidelines |