The type and quantity of accessories may change from time to time. Please refer to the actual items you receive.
The P1S combo package comes with a Screen, Spool Holder, Filament, Spare Hotend, Nozzle Wiping Pads, Power Cord, Unclogging Pin Tool, PTFE Tube, Bambu Scraper, Allen Keys, AMS buffer(Pre-installed on the printer), 4pin bus cable, 6pin bus cable, hotend clip, double-sided tape, filament cutter blade, thermal grease, lubricant grease, and Textured PEI Plate (Pre-installed on the heat bed of the printer).
Please note that the products you receive may undergo material changes and version iterations. Therefore, we kindly request you refer to the actual product you receive.
| NO. | Physical photos | Description | Application | Marks |
| 1 |
 |
Bambu textured PEI plate | Placed on the heat bed to hold the model. | Pre-installed on the heat bed of the printer |
| 2 |
 |
LCD Screen | ||
| 3 |
 |
Spool holder | It is installed on the back of the printer, fixed with 2 screws. | |
| 4 |
 |
Bambu Reusable Spool | Installed with Filament below | |
| 5 |
 |
One spool of PLA Basic 250g and two spools of 250g filament in random type and color | Installed with Reusable Spool above | |
| 6 |
 |
Spare 0.4 mm stainless steel hotend | P1S spare hotend, replace the original nozzle when it is damaged. | - Filament Guide |
| 7 |
 |
Nozzle Wiping Pad | Spare nozzle Pad, replace it when the Wiping Pad is damaged. | |
| 8 |
 |
Power Cord | ||
| 9 |
 |
Unclogged tool for 0.4 mm nozzle | Special unclogged tool for the 0.4 mm hot end | The hot end has been separated from the extruder and is heated. |
| 10 |
 |
PTFE Tube | ||
| 11 |
 |
Bambu scraper | Print 'Scraper grip' from the built-in files， and then install the scraper to it. | |
| 12 |
 |
4 pin bus cable | Connect AMS hub/buffer and printer | |
| 13 |
 |
6 pin bus cable | Connect AMS hub/buffer and AMS | |
| 14 |
 |
AMS buffer | Introduction to AMS | Pre-installed on the printer |
| 15 |
 |
H1.5/H2.0 hex keys | Disassembly and assembly tools | |
| 16 |
 |
Thermal grease | Improve the thermal conductivity of the thermistor、ceramic heater with the nozzle, which may be used when replacing the above accessories. | |
| 17 |
 |
Lubricant grease | Special grease for lead screw | |
| 18 |
 |
Spare screws for the extruder | ||
| 19 |
 |
hotend retaining clip | The retaining clip is used to hold in place both the ceramic heater and thermistor) | |
| 20 |
 |
filament cutter blade | To cut the filament | |
| 21 |
 |
double-sided tape | For printed Phone Holder | |
| 22 |
 |
Quick start guide | ||
| 23 |
 |
Disclaimer and Safety Guidelines |