¶ Issue Description
The chamber temperature sensor primarily provides temperature information inside the printer chamber and is located on the upper part of the front door inside the printer. This error message indicates a possible open-circuit issue with the chamber temperature sensor.
Possible causes include:
- The chamber temperature sensor may have a loose connection with the MC board.
- The sensor cable might be broken or the sensor itself may be faulty (replacement required).
¶ Troubleshooting
Warning: Please power off the printer before troubleshooting!
¶ Tools, Equipment and Materials
H2.0 hex key (Allen wrench)
¶ Fault Isolation Process
¶ Solutions
Users may adjust the order of these solutions as needed.
¶ Step 1: Remove the Rear Panel
Refer to the Rear Panel Replacement Wiki for detailed instructions.
¶ Step 2: Remove the Purge Chute
Refer to the Purge Chute Replacement Wiki for details.
¶ Step 3: Expose the MC Board and Check Heater Connection
- With the MC board exposed, locate connector 9, which corresponds to the chamber temperature sensor (as shown below).
- Check if the connector is loose and try reconnecting it.
¶ Step 4: Power-On Test and Reassembly
- Power on the printer.
- If the warning is cleared, the issue has been resolved. Reinstall the waste chute and back panel to complete the troubleshooting process.
- If the warning persists, the sensor cable may be broken. Please contact customer support for further assistance.
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!