¶ Issue Description
The BirdsEye Camera is not installed, preventing the calibration of the laser module.
¶ Troubleshooting
¶ Tools, Equipment and Materials
H2.0 Allen key
¶ Solutions
-
Refer to this wiki to confirm whether the BirdsEye Camera is installed correctly. (The camera must be installed after the printer is powered off and cannot be hot-swapped!)
- Remove the AP board cover and check if the BirdsEye Camera cable is properly connected to the AP board interface. Try disconnecting and reconnecting it several times.
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!