H2.0 hex cable
Power off the printer, and eject the SD card.
Refer to the relevant content of the Rear panel to remove the rear panel.
Refer to the relevant content of the AP board to remove the screen and front cover, and remove the AP board from the beam to expose the MC-AP connector.
Disconnect the MC-AP cable from the connectors on the AP board and MC board respectively.
Remove the fixing tapes, release the cable from the cable slot, and remove the MC-AP cable.
Pass the MC-AP cable through the cable holes and press it into the cable slot.
Connect the two ends of the cable to the corresponding connectors on the AP board and the MC board respectively.
Refer to the relevant content of the AP board to install the AP board and screen.
Fix the MC-AP cable along the beam with tapes.
Refer to the relevant content of the Rear panel to install the rear panel.
Power on the printer, and run the device self-check process. If the self-check passes, the operation is successful.