Note: There are no spare parts for this item
H2.0/H1.5 hex key
Disconnect the power cord cable.
Refer to the related content of Rear panel and Excess chute to remove the rear panel and the excess chute.
Remove the 2 screws as shown below with an H2.0 hex key, and then remove the cable railing.
Remove the 6 screws of the cable cover with an H1.5 hex key, and then proceed to take off the casing.
When installing the new cable cover onto the printer, be careful not to accidentally clip or catch any of the cables or wires. Once the cover is in place, secure it by tightening the screws.
Reinsert the cable railing back to its original position and proceed to fasten the 2 screws.
Refer to the related content of Excess chute and Rear panel to install the excess chute and rear panel.
Examine the installation ensuring the outer panel is properly attached and ensure all screws are correctly fastened.