Currently, the X1 series is supplied with two types of micro LiDAR and two types of TH board. They are not fully compatible. The printer would perfrom hardware configration compatibility check before each print, and raise errors if the check failed.
Step 1. Check hardware configration
Referees this wiki to check and record hardware serial number(SN).
https://wiki.bambulab.com/e/en/x1/manual/micro-lidar-model
Step 2. Check hardware compatibility
The compatibility matrix of TH board and Micro Lidar is as follows:
| Micro Lidar Single Red laser SN: 00ExxA |
Micro Lidar Dual IR laser SN: 00ExxB |
|
|---|---|---|
| TH board SN 003xxA 003xxB |
√ | -- |
| TH board SN 003xxC 003xxD 003xxY |
-- | √ |
x represents any number
Y represents a letter after the letter D, such as E,F
-- not Compatible
√ compatible
Step 3. Replace either the Micro-Laser or TH board assembly to meet the compatibility
https://wiki.bambulab.com/en/x1/maintenance/replace-micro-lidar
https://wiki.bambulab.com/en/x1/maintenance/replace-the-th-board-assembly
HMS_0500-0300-0001-0021: Hardware incompatible, please check the laser.
0500-0300-0001-0021
We hope that the detailed guide we shared with you was helpful and informative.
We want to ensure that you can perform it safely and effectively. If you have any concerns or questions regarding the process described in this article, we encourage you to reach out to our friendly customer service team before starting the operation. Our team is always ready to help you and answer any questions you may have.
Click here to open a new ticket in our Support Page.
We will do our best to respond promptly and provide you with the assistance you need.