¶
Quick Start Guide
X1/X1-Carbon Quick Start Guide
X1-Carbon Combo Quick Start Guide (AMS included)
¶
Introduction
Introduction to X1/X1-Carbon
Introduction to AMS
Introduction to Bambu Studio
¶
Setting Up
Unboxing X1Carbon Combo
Unboxing X1/X1C
Supplementary instructions for accessories in the box
Connect AMS to X1/X1C
Setup for the first print
AMS setup and Filament Loading
Connect AMS Hub and multi-AMS
Bambu Lab Extension Board Manual
¶
Printing
Prepare for printing
Printing on the Cool Plate
Printing on the Engineering Plate
Loading filament (without AMS)
Replacing filament
Switch from AMS back to spool holder
Print from SD Card
Print from Bambu Studio
Control and monitor printing from Bambu Handy
[waiting for content]
First print with an internal file
Change printer settings
[waiting for content]
Using a large spool on the spool holder
Multi-color printing operation guide
Filament Guide
¶
Firmware Upgrading
Firmware Upgrading
X1/X1-Carbon and AMS Firmware Release History
¶
Further Reading
Bambu Lab Micro Lidar Introduction
Bambu Lab Mods to be cautious about
Auto Bed Levelling (ABL)
[waiting for content]
Active Vibration Compensation
[waiting for content]
Dynamic Flow Calibration
[waiting for content]