Find all AMS articles by clicking this link. The page results will display all Wiki articles tagged for the AMS
¶ Quick Start
- Introduction to AMS
- AMS Glossary
- AMS main functions and workflow introduction
- AMS quick start guide
- AMS notes
¶ Print Settings
- Connect AMS to X1/X1C
- Connect AMS to P1 series
- AMS setup and Filament Loading
- Connect AMS Hub and multi-AMS
- Disable unloading and flushing to save filaments when printing the same material
¶ Troubleshooting
- AMS LED status
- AMS power on failure
- AMS is not detected by the printer
- The printer shows that AMS filament ran out
- AMS first stage feeder troubleshooting
- AMS hub cleaning
- Dismantling and cleaning the filaments hub
- How to distinguish the version of AMS main board
- AMS loading&unloading failure troubleshooting
- PTFE Tube Wear in AMS and Maintenance Recommendations
¶ Maintenance Guides
In this section, you can find detailed guides related to the recommended procedures that should be followed with the AMS to ensure smooth operation and a long lifetime of the product.
Bambu Lab AMS Maintenance Recommendation
¶ Part Replacement Guide
¶ AMS body
- AMS main frame installation tutorial
- AMS bottom cover unit installation tutorial
- Replacing AMS bottom cover unit/ external housing unit
¶ AMS feeding system
- AMS filaments hub installation tutorial
- AMS active extrusion wheel assembly installation tutorial
- AMS first-stage feeder installation tutorial
- AMS feeding funnel installation tutorial
¶ Circuit board
- AMS interface board installation tutorial
- AMS power board installation tutorial
- AMS main board installation tutorial
¶ Others
- AMS cables pack (5 in 1) installation tutorial
- Replace AMS sealing kit
- The magnets in the AMS filaments hub installation tutorial
¶ Firmware Upgrading
¶ Further Reading