P1P is simpler than X1, but still a complex electromechanical device full of sensors, electronics, actuators, and mechanical parts.
Parts wear, or faults are unavoidable during its long service. Regular maintenance will reduce the wear and increase the life of the printer.
There are many guides here that could help people to do service or change faulty parts.
As a proud owner of a Bambu Lab P1P printer, you must maintain the performance of your printer by performing periodic maintenance to ensure it continues to run and operate smoothly.
The housing of toolhead installation tutorial
PTFE tube to the toolhead installation tutorial
PTFE tube anchor installation tutorial
Complete hotend assembly installation tutorial
Extruder unit installation tutorial
Extruder Filament Sensor installation tutorial
PCBs on the toolhead installation tutorial
Toolhead cable installation tutorial
Front cover installation tutorial
Rear panel installation tutorial
Chamber camera(Optional) installation tutorial
Cable chain (Optional) installation tutorial
Excess chute installation tutorial
Cable cover installation tutorial
AP board installation tutorial
WIFI antenna installation tutorial
Clip (For the camera connector) installation tutorial
Heat bed installation tutorial
Heat bed signal cable installation tutorial
MC board installation tutorial
MC-AP cable installation tutorial
Power board installation tutorial
AC board installation tutorial
XY tensioner idler installation tutorial
XY motor installation tutorial
XY timing belt installation tutorial